How to assemble a doll case
Our display cases are delivered as completed products, but depending on the product, we can send it to you in an unassembled state. This page is for reference in that case.
How to assemble a wooden doll case: Type 1 with front door and tassels. (Please prepare your own wood glue.)
FIG. 1FIG. 2
- 1. Pour glue into the hole in the base until it is about half full, as shown in Figure 2 (commercially available wood glue will do).
- 2. Place the pillars on the base. There are three types of pillars, some with tops and bottoms, so be careful not to mix them up. (Fig. 3, 4) Fig. 4 shows the shape of the pillars for a case with tassels.
- 3. Insert the back panel and glass. (Fig. 5)
FIG. 7
FIG. 8
- 4. Apply glue to the recessed part of the top board in the same way as the base, and lightly insert the heads of the pillars.When doing so, be careful not to insert the pillar on the front right so that the door pin can be inserted later. (Fig. 6, 7)
FIG. 10
FIG. 11
- 5. While inserting the pin part of the right door into the hole in the base and the hole in the top plate, insert the pillar all the way into the recess in the top plate. (Fig. 9)
- 6. Press down on the top plate that was lightly inserted in step 4 with your hand from directly above and insert it all the way. If the pillar is not properly inserted in the hole and the bag and glass are not properly inserted in the groove, it will not go all the way. Please be careful.
- 7. If there are tassels, attach them.