Kimekomi Hina Doll Material No. 167 Juho Prince

Accessories

Prince; (Crown, staff, osan, string, tassel, both hands)

Princess; (Hinoki fan, string, lilia, tamagushi, both hands)

Body (Fabric Orientation and Type)

Prince

• The numbers ① to ⑦ indicate the fabric numbers. The bottom fabric will become the fabric for the hakama.
• The arrows indicate the orientation of the fabric when applying.
• First, make sure to do corrections properly. The final output will be determined by the initial corrections. If you apply the fabric in the state shown in Figure 1, the finish will also look like this. Please do the correction properly as shown in Figure 2.
• Be careful not to confuse the hands of the prince and princess. The hand with rounded fingers is the prince's right hand.
• To attach the eboshi, first attach the string to the eboshi and apply glue to the prince's mage. Apply a small amount of glue so it’s not visible from the front, in the shadow of the knot at the neck, and tie it in a square knot at the neck. After that, cut off any excess string. In this case, the bow knot will be attached later with glue.
• For information on how to attach the string to the eboshi, please check here.

Princess

• The numbers ① to ⑨ indicate the fabric numbers. The bottom fabric will become the fabric for the hakama.
• The arrows indicate the orientation of the fabric when applying.
• The two grooves marked A are unnecessary, so please fill them in.
• The points to note are almost the same as for the prince.
• In the case of the princess, the bottom of the kimono is also reversed, so it is better to apply a little glue here.
• The string for the tamagushi can be found here. For the hinoki fan's string, please refer to here.